MX Flexi Seal Strip Waterproof Tape for Upstand Shower Tray & Bath

The MX Flexi Seal Strip is a professional waterproofing solution applied by hand to the wall facing sides of shower trays or baths prior to installation. The flexibility of the product makes it equally suitable for the new build, repair or renovation. Creates a water tight seal between the tray and wall

• Remove the protective film from the edge of the tray to which the seal strip is to be attached but leave it over the base of the tray to protect the trays surface during installation.
• Wipe the surfaces clean where the strip will be attached first with a clean damp cloth, allow to dry and then wipe with the IPA wipe supplied in the kit.
• Determine the length of the strip required to seal around the shower tray and cut to length with scissors with an additional 20mm extra
• Peel back approximately 20cm of backing from the black adhesive strip.
• Attach to the edge of the shower tray so that it is square and the edge protrudes at least 20mm above the edge of the tray.
• Using a small roller or other appropriate tool roll the seal strip so that it attaches firmly to the edge of the tray removing any bubbles or creases, paying particular attention to the corners.
• Gradually remove the cover strip in sections and roll on the seal so it attaches firmly and square to the edge of the tray, making sure there are no gaps between the tray and the seal strip. Trim off any excess strip.
• Put a protective bead of silicone or other suitable flexible sealant between the tray and the tile.
• Remove the remaining protective film over the rest of the shower tray.